Configuring the Code Settings
Here we talk about how to configure codes and jumpers for the Hunter 85095 Remote Control. When multiple fans are in close proximity, it may be necessary to assign different codes to each fan to ensure that the operation of one fan does not interfere with another. This can be achieved by adjusting the position of a group of three jumpers located together in both the transmitter and the receiver. These jumpers, which are small in size, can be manipulated using a pair of small pliers or tweezers.
In the transmitter, access the jumpers easily from the battery compartment. The receiver, situated in the switch housing, also has a set of three jumpers that need to be adjusted to match the transmitter settings. Refer to Figures 1 and 2 for visual guidance.
To configure the jumpers in the receiver, remove the receiver from the switch housing and set the jumpers in the same positions as those in the transmitter (see Figure 2). When replacing the receiver, ensure that the mounting holes at the top of the switch housing align with the corresponding slots in the top of the receiver.
Figure 4 – Assembly of Remote Holder Jumper Switch Transmitter Back Figure 1 – Jumper Switches in the Transmitter Figure 2 – Jumper Switches in the Receiver Upper Switch Housing Lower Switch Housing Plug Connector Assembly Screw Figure 3 – Assembly of Lower Switch Housing
If assembly proves challenging, check the alignment of the three slots at the top of the receiver module with the mounting holes in the lower switch housing; they should align seamlessly. Tighten the three assembly screws securely.
CAUTION: Ensure that the screws are snug to prevent potential separation during operation.

Installing the Remote Holder
The transmitter comes with a holder that can be affixed to an existing toggle switch wall plate. This holder serves to prevent misplacement of the transmitter by providing a permanent receptacle (see Figure 4). Optionally, mount the holder on a wall in a convenient location.
Assembling the Switch Housing
Connect the lower switch housing to the upper housing, as shown in Figure 3. Insert the plug from the upper housing into the plug receptacle in the receiver module, ensuring correct alignment. Align the lower switch housing with the upper housing and secure them together with the three screws and lockwashers provided.
Jumper Switch Receiver Bottom Lower Switch Housing Pull receiver out of switch housing.
Caution: Risk of Electrical Shock! All wiring must adhere to national and local electrical codes. If unfamiliar with these codes, consult a qualified electrician. To prevent overheating and potential damage, refrain from installing to control a receptacle, fluorescent light fixture, motor-operated appliance, or transformer-supplied appliance. Use solely to control one paddle-blade ceiling fan and incandescent light fixture.
This device complies with part 15 of the FCC rules. Any unauthorized changes or modifications by Hunter Fan Company may void the user’s authority to operate this equipment.
Operation Is Subject To The Following Two Conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation. Note: Unauthorized changes or modifications to the transmitter or receiver may void the user’s authority to operate this remote control.
Symptom Possible Causes Solution Troubleshooting
- No functions operate.
- Operates only at close range.
- Inconsistent operation.
- Main Power not restored. Replace fuse. Turn ON circuit breaker. Turn ON wall switch.
- Transmitter and receiver jumper switches do not match.
- Battery too weak.
- Set transmitter and receiver to same jumper switch setting. Replace with new, alkaline battery.
- Battery too weak. Replace with new, alkaline battery.
- RF interference. Turn OFF wall switch for 5 seconds, then turn back ON.
- Continuing RF interference. Change jumper switch settings to a different code in both Transmitter and Receiver.

I have model 23457 and the remote stopped working. How can I replace the remote?
Can I purchase a remote (85095-01-000)?
Hunter Remote 85095-02. is it normal for the small red light to remain on at all times?